Installation

Due to photoconductive resistance built-in camera isn’t mounted on the LED board, Please attention to make photoconductive resistance and lens keep the same direction when installing, then photoconductive resistance have induction exterior light environment, in order to decide whether to open white light

Mounting position and how to install/equip with DVS, please refer to《Bus Vehicle People Counting Device Installation Guidebook》

Fault analysis

If video effect on the bus is very dark, people counting effect is bad, please confirm them according to the following steps

1) Ensure LED board work well

Keep out photoconductive resistance and see whether LED board to light, if not please replace camera to test

2) Ensure photoconductive resistance placed in the correct direction。

  When mount camera, ensure the direction of photoconductive resistance and camera is same, that’s Photoconductive resistance when installation should be vertical, end face of photoconductive resistance and camera are leveled